354PS 3.0L Audi S4, S5, SQ5 Tuning

3.0 TFSI EA839

You will find the 3.0 TFSI V6 EA839 engine nested in the Audi S4/5 B9 and SQ5. Developing around 354PS between 5400-6400rpm, and 500NM from 1370-4500rpm it has all the right ingredients, however as we know there is room for improvement. Unusually for a V6 it has a 90° block angle, rather than the more traditional 60°, with a balance shaft to compensate for the torque inertia and promote smooth running. Also, thanks to its aluminium construction it’s lighter than the previous 3.0 TFSI V6 variants.

Intensively tested and refined on our own in house S4 along alongside our Global Development Programme, throttle response has been dialled in to give the driver a deeper sense of connection and involvement with the car. Without compromising on the refinement of the driving experience, one of the main selling points of this engine and vehicle. Rather than being pulled, the hike in torque gives the feeling of a firm push from the bottom of your back, and it’s addictive, the car now begs to be driven. Optimised power delivery and with much more torque at its disposal, you can now drop below 4000rpm and still pull hard out of any corner without hesitation.

GET FAR MORE THAN A PEAK POWER FIGURE

Revo offers some of the most substantial performance increases on the market, however, only the driven know that peak figures form part of a much bigger picture and are never the sole focus during Revo’s development process; it’s all about the drive. Only Revo offers a perfect balance of performance, economy, and engine longevity.

Revo performance ECU Software gives you much more than just an increase in power and torque. A large part of development is based on driving scenarios and feedback; our calibration doesn’t just offer great dyno curves and peak power/torque figures but an exhilarating driving experience. Expect smooth and refined response at low RPM & partial throttle, with huge gains at wide-open throttle and throughout the whole rev range.